The SHV800v2 is an incredible 800 to 1300oz/in servo designed for the high impact punishment of R/C Rock Crawlers and Rock Racers, but is at home in any vehicle that needs high torque, ultra fast speeds, and massive gear strength! It is powered directly by a 2S to 4S LiPo battery via JST connection on your ESC's battery plug, eliminating the need for an external BEC! Clean up your wiring, gain space in a tight rig, and enjoy massive performance at industry leading high efficiency from the high quality brushless motor and circuitry. The V2 has changed mounting tabs to accommodate more chassis mounted servo installs, dual wire for better signal and power handling
FEATURES:
- Full aluminum Case with O-Ring Seals
- All steel machined gears with industry leading pin strength
- Oversized Brushless motor with 200C rated Neodymium magnets
- 24cm radio signal lead
- 24cm power lead with female JST plug
- 120 degree rotation
- 1 Year Warranty
SPECIFICATIONS:
- Weight: 94g
- Dimensions: 38.7mm high x 20mm wide x 40mm long
- Spline: 25 tooth (Futaba type) M3 threaded
- Torque @ 8.4v & 4 amp: 805 oz/inch (58kg/cm)
- Speed @ 8.4v: 0.21 sec
- Torque @ 12v & 4.1 amp: 1083 oz/inch (78kg/cm)
- Speed @ 12v: 0.14 sec
- Torque @ 15v & 5.1 amp: 1333 oz/inch (96kg/cm)
- Speed @ 15v: 0.11 sec
You must use a radio with endpoint adjustment for proper installation. The battery must be disconnected from the ESC AND servo when not in use to prevent damage to the servo and/or battery. Do not power the servo directly from a battery balance port. Doing so can damage the servo and will void the warranty. Moly (marine) grease is recommended when lubricating the gears. Dielectric grease is recommended on the power board and potentiometer if looking to increase water resistance.
