Direct fit into Axial SMT10
CNC machined aluminum transmission case
CNC machined aluminum 3mm thick motor mount
Wide hardened steel 48 pitch gears
Hardened steel output shaft
Shift servo mount fits standard and mini servos
Same mounting as stock Axial Wraith & SCX10 transmission
Fits stock Axial transmission input shaft
Fits stock Axial transmission gear cover
Direct fit into Axial Wraith
Note:
This is a conversion kit, not a complete transmission.
To complete the assembly it requires:
Axial transmission input shaft (AX31149)
Axial 20T drive gear + pin (AX30394, AX30162)
Axial Slipper plates + pads (AX31026, AX31068)
Axial 56T 32P Spur gear (AX31027)
Axial 13T 32P Pinion gear (AX30724)
Axial Slpper spring (AX30413)
Axial Gear cover (AX80078)
Will require shifters to be removed from Wraith interior.
This can be used on an SCX10 but shorter driveshafts are required.
Assembly instructions can be found HERE
Replacement output shaft is available (SSD00088)
Internal 1st gear ratio: 4.91:1 (stock Axial is 2.6:1)
Internal 2nd gear ratio: 1.8:1
Output shaft OD: 5mm
Weight (when fully assembled with shift servo) : 335g
1 X 2 Speed Transmission assembled with motor mount
4 X M3 x 10mm flat head screws
3 X M2.5 x 6mm flat head screws
4 X M3 x 8mm button head screws
2 X M3 x 12mm button head screws
1 X M3 x 15mm threaded set screw
2 X 3mm mini plastic rod ends