1965 rpm/volt / Use with FLUX RAGE ESC
The Flux Scream is the perfect match for any 1/8th scale electric buggy or truggy!
With 1965Kv on tap, this massive brushless motor gives jaw-dropping acceleration and blinding top speeds! Match it with the #101712 Flux Rage 1:8th scale 80Amp Brushless ESC for a perfect blend of grunt and all-out speed with twin 2S power for up to 14.4 volts of juice!
- Shaft Diameter - 5mm
- Diameter - 42mm
- Length - 68mm (without shaft)
- Shaft length - 18.5mm
- Weight - 345g
- Connector - 6mm Bullet
- Machined aluminum casing
- Ball bearing supported shaft
NOTE: Before driving in wet conditions, make sure that other electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.
THIS PART FITS THE FOLLOWING KITS / PARTS: